User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
EKI-1361 & EKI-1362 Series User Manual 48
To access this page, click Networking Settings > Security > Filter.
Figure 4.14 Networking Settings > Security > Filter
4.5 Wireless Settings
4.5.1 Basic
To access this page, click Wireless Settings > Basic.
Figure 4.15 Wireless Settings > Basic
Item Description
Filter
Enabled Click the radio button to enable or disable the Filter policy.
Direction Click the drop-down menu to select the direction of the data packet
traffic for the entry: LAN to WAN, WAN to LAN.
Source IP Enter the IP address of the sender address.
Destination IP Enter the IP address of the destination address.
Protocol Click the drop-down menu to select the protocol type for the entry:
TCP, UDP, ICMP.
Source port Enter the port number of the sender IP address.
Destination port Enter the port number of the destination IP address.
Delete Click Delete to remove the entry from the Filter policy.
Add Click Add to include the entry in the Filter policy.
Apply Click Apply to save the values and update the policy.