User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
43 EKI-1361 & EKI-1362 Series User Manual
4.4.2.2 DHCP/AutoIP Network Mode
To access this page, click Network Settings > LAN.
Figure 4.8 Network Settings > LAN > DHCP/AutoIP
The following table describes the items in the previous figure.
Item Description
Local Hostname Enter the device name: up to 31 alphanumeric characters.
Domain Name Enter a string to specify the domain name for the interface.
Network mode Click the drop-down menu to select the IP Address Setting mode:
Static or DHCP.
DHCP Timeout Enter a value in seconds (default: 30) to specify a timeout period to
obtain a response from the DHCP server, the device will give up
the request and take next action.
Subnet Mask Enter a value to specify the IP subnet mask for the interface. The
default is 255.255.255.0.
Default Gateway Enter a value to specify the default gateway for the interface. The
default is 192.168.1.254.
DNS Click the radio button to select the DNS mode: Automatic or
Specific.
DNS 1 Enter a value to specify the default DNS 1 for the interface. The
default is 192.168.1.1.
DNS 2 Enter a value to specify the default DNS 2 for the interface.
Speed & Duplex Click the drop-down menu to select the transmission parameters:
Auto-Negotiation, 100M & Full Duplex, 100M & Half Duplex, 10M &
Full Duplex, 10M & Half Duplex.
MAC Address Display the MAC address to which packets are statically
forwarded.