User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
EKI-1361 & EKI-1362 Series User Manual 42
IP Address Enter a value to specify the IP address of the interface. The default
is 10.0.0.1.
Subnet Mask Enter a value to specify the IP subnet mask for the interface. The
default is 255.255.255.0.
Default Gateway Enter a value to specify the default gateway for the interface. The
default is 192.168.1.254.
DNS Click the radio button to select the DNS mode: Automatic or
Specific.
DNS 1 Enter a value to specify the default DNS 1 for the interface. The
default is 192.168.1.1.
DNS 2 Enter a value to specify the default DNS 2 for the interface.
Speed & Duplex Click the drop-down menu to select the transmission parameters:
Auto-Negotiation, 100M & Full Duplex, 100M & Half Duplex, 10M &
Full Duplex, 10M & Half Duplex.
DHCP Server
DHCP Server Click to enable or disable the DHCP server function.
Start IP Address Enter an IP address to specify the starting address for the DHCP
pool.
Pool Counter Enter a string to specify the number of authorized DHCP client.
MAC Address Display the MAC address to which packets are statically
forwarded.
Leasetime Enter values to specify the time a device is authorized access to
the IP address: Day, Hour, Minute, Seconds.
Apply Click Apply to save the values and update the screen.
Note! All new configurations will take effect after rebooting. To reboot the
device, click Administration > Tools > Reboot.
Item Description