User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
39 EKI-1361 & EKI-1362 Series User Manual
4.4 Network Settings
4.4.1 Wireless WAN
To access this page, click Network Settings > Wireless WAN.
The Interface screen allows user to setup the WAN interface and its network function
mode.
When Network Mode is disabled (default), the WAN Interface Settings appear as
follows.
Figure 4.3 Network Settings > Wireless WAN > Network Mode
The following table describes the items in the previous figure.
Memory
Total Available Displays the total amount of physical memory installed RAM in
kiloBytes (kB) on the device.
Free Displays the currently unused RAM in kiloBytes (kB) on the device.
Buffered Displays the RAM in kiloBytes (kB) set aside as a temporary
holding place for data.
Local Network
Local IP Address Displays the assigned IP address of the device.
Local Netmask Displays the assigned netmask of the device.
MAC Address Displays the MAC address of the device.
WAN Network
WAN IP Address Displays the assigned IP address of the WAN entry.
WAN Netmask Displays the assigned netmask of the WAN entry.
WAN Default Gateway Displays the assigned default gateway of the WAN entry.
DNS1 Displays the assigned DNS1 of the WAN entry.
DNS2 Displays the assigned DNS2 of the WAN entry.
DHCP Leases Displays the leased IP assignments by the DHCP server.
Item Description
Item Description
Network Mode Click the drop-down menu to select the mode type: Disable
(default), Static, DHCP.
MAC Address Displays the current device’s MAC address.
Apply Click Apply to save the values and update the screen.