User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
37 EKI-1361 & EKI-1362 Series User Manual
4.1 Overview
EKI-1361 & EKI-1362 Series device can be configured through a web interface. By
using a standard web browser, the same procedure as with the Windows
configuration utility can be used. In the browser’s address field, enter the IP Address
of your EKI-1361 & EKI-1362 Series device. The default IP setting is 10.0.0.1, but
you should use the IP which you have previously assigned for this device. Once the
IP is entered, you will be presented with the following windows.
4.2 Accessing the Web Page
4.2.1 Accessing the Web Page via Configuration Utility
To access the web page via configuration utility:
1. Select Ethernet under the desired device.
2. Click Launch Browser.
Figure 4.1 Accessing the Web Page via Configuration Utility
4.2.2 Accessing the Web Page via Web Browser
Once the device is installed and connected, power on the device. The following
information guides you through the logging in process.
1. Launch your web browser on the PC.
Note! Before using the web-based configuration, make sure your host PC
Ethernet network IP domain is as same as the device, or it can establish
the TCP connection with the device.
Note! It is recommended that you use Microsoft Internet Explorer 7.0 or
higher.