User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
EKI-1361 & EKI-1362 Series User Manual 32
3.5.2 Restore to Factory Default Settings
The configuration utility provides the function to restore the device to factory default
settings.
Figure 3.13 Restore to Factory Default Settings
The confirm message will display after clicking Restore to Factory Default
Settings. If you really want to restore the serial device sever to factory default
settings, please click Yes button to continue.
Power off the device within ten seconds. After reconnecting the power, all settings will
be reset to the factory default. If the power supply remains connected for more than
ten seconds, the device will not be changed.