User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 2.1 Hardware
- 2.2 Connecting Hardware
- 2.3 Reset Button
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Port Configuration
- 4.7 Monitor
- 4.8 Alarm
- 4.9 Administration
- 5 Telnet/Serial Console Configuration
iv EKI-1361 & EKI-1362 Series User Manual
Declaration of Conformity
CE
This product has passed the CE test for environmental specifications. Test conditions
f
or passing included the equipment being operated within an industrial enclosure. In
order to protect the product from being damaged by ESD (Electrostatic Discharge)
and EMI leakage, we strongly recommend the use of CE-compliant industrial
enclosure products.
FCC Class B
This equipment has been tested and found to comply with the limits for a Class B
d
igital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
R
eorient or relocate the receiving antenna.
I
ncrease the separation between the equipment and receiver.
C
onnect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
C
onsult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
r
esponsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
f
ollowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC RF Radiation Exposure Statement:
1. Th
is Transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
2. Th
is equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 centimeters between the radiator and your body.
The emissions are maintained within the band of operation under all conditions of
normal operation as specified.