User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Utility Configuration
- 4 Web Interface
- 4.1 Overview
- 4.2 Accessing the Web Page
- 4.3 Overview
- 4.4 Network Settings
- 4.5 Wireless Settings
- 4.6 Alarm
- 4.7 Administration
- 5 Telnet/Serial Console Configuration
18 EKI-6233BN User Manual
8. Tighten the screws on the terminal block to secure it to the terminal block
receptor.
If there is no gap between the terminal block and the terminal receptor, the
terminal block is seated correctly.
Figure 2.19 Securing a Terminal Block to a Receptor
2.3 Reset Button
Reset configuration to factory default:
Press and hold Reset button for 10 seconds.
System reboot:
Press and hold Reset button for 2 seconds.
Note! Do NOT power off the gateway when loading default settings.