User's Manual


EKI-6331AN_User Manual_for NCCPage26
bonding that allows EKI-6331AN to use two channels at once. Two options are available: Upper
Channel and Lower Channel.
Channel Mode
4 levels are available: 40MHz, 20MHz, 10MHz and 5MHz. 40MHz can enhance data throughput,
but it takes more bandwidth, thus it might cause potential interference.
Antenna
By default, EKI-6331AN uses its built-in antenna for directional transmission;.
Maximum Output Power (per chain):
Specify the signal transmission power. The higher the output power is, the wider the signal can
cover, but the power consumption will be greater accordingly.
The output power here is counted from the RF single chain only not including the 15dBi
internal antenna.
The maximum output power will vary depending on the country selected in order to
comply with the local regulation.
Data Rate
Usually “Auto” is preferred. Under this rate, EKI-6331AN will automatically select the highest
available rate to transmit. In some cases, however, like where there is no great demand for speed,
you can have a relatively-low transmit rate for compromise of a long distance.
Extension Channel Protection Mode
This is to avoid conflict with other wireless network and boost the ability of your device to catch all
legacy devices transmissions. However, it may decrease wireless network performance.
Compared to CTS-Self; the transmission amount of CTS-RTS is much lower.
Enable MAC Clone
Available in wireless client mode, it hides the MAC address of EKI-6331AN while displays the one
of associated wireless client or the MAC address designated manually.
Note: