User manual

VLAN configuration - Port-based VLAN
Packets can go among only members of the same VLAN group. Note all unselected ports are treated as
belonging to another single VLAN. If the port-based VLAN enabled, the VLAN-tagging is ignored.
In order for an end station to send packets to different VLAN groups, it itself has to be either capable of
tagging packets it sends with VLAN tags or attached to a VLAN-aware bridge that is capable of
classifying and tagging the packet with different VLAN ID based on not only default PVID but also other
information about the packet, such as the protocol.
Figure 3.1-21 Port-based Mode
•
Pull down the selection item and focus on
Port Based
then click
A
pply
to set the VLAN Operation
Mode to
Port Based
.
•
Click
A
dd
to add a new VLAN group.
EKI-2548I_Manual_ed2 42