User manual

System Log – System Log Configuration
Configure the system event mode to collect system log.
• System Log Mode: Select the system log mode—Client Only, Server Only, or Both.
• System Log Server IP: Assign the system log server IP.
•
When System Log Mode is set to
Client Only
, the system event log will only be reserved in the
switch’s RAM until next reboot. When the mode is set to
Server Only
, the system log will only be sent
to the system log server, and therefore you have to type the IP address in the System Log Server IP
column. If the mode is set to
Both
, the system log will be reserved in the switch’s RAM and sent to the
specific server.
•
Click
Reload
to refresh the events log.
•
Click
Clear
to clear all current events log.
•
After configuring, click
A
pply
.
Figure 3.1-7 System Log Configuration
27 Chapter3