User`s manual

Common mistakes in usage
82 User’s Manual V2.00 MTC 6 Series
15.4. Mounting/Installation
• Only use suitable mounting brackets and screws permitted by DLoG.
• Ensure that ball-and-socket bases and fastening arms are securely attached.
• Follow the instructions carefully when attaching all outgoing cables to the strain
relief rail.
• The WLAN antenna should not be used as a handle when turning the terminal.
• All fastening brackets and mounting parts supplied by DLoG are only intended for
use in the mounting of terminals and peripheral devices and may not be used for
other purposes.
• When mounting peripheral devices, follow the manufacturer’s instructions. This is
particularly important when welding or drilling supporting parts.
• To avoid any accidents, make sure your field of vision is not restricted in any way
when mounting peripheral devices. Observe all accident prevention regulations.
15.5. Mobile application on vehicles
• Observe correct voltage ranges.
• Ensure that supply lines are fused correctly.
• Lay the supply cable so that it will not get crushed or frayed.
• Read the labeling on the cable and connect the supply cable with the correct
polarity.
• Cut the supply cable as short as possible. This avoids tangled cables and improves
the quality of the power supply.
• Observe the vehicle manufacturer’s instructions for connecting additional loads, for
instance, in conjunction with an emergency shut-off switch.
• Be sure that the connection of the line is as directly as possible to the battery and
not to power supply lines with a great deal of interference (e.g. the engine power
supply) or otherwise affected by consumers.
• Connect the supply cable to a suitable place. Ensure that the connecting cable has
an adequate cross section and ampacity at the connection point.