Instruction manual

WLAN
42 Manual V3.10 DLoG Config
Connect program
Start program on each
new connect or start
after ...
This setting is used to start any arbitrary software
program.
The program may optionally be started:
• after every entry into the WLAN area
• or periodically; if necessary, enter the time
interval.
If a WLAN connection exists, the program is
started at the specified intervals.
Note: the prerequisite is that there is a functioning
WLAN connection!
An application example: The DLoG Industrial PC on a
forklift has an online connection to the warehouse
management database. If the forklift leaves the WLAN
area, this online connection is interrupted. To receive
updated data immediately after entering the WLAN area
again, the Connect Program function is used to start a
database update automatically.
Program Enter the program to be started here.
Extended settings
Select WLAN card Detect the radio card automatically or select it from the
list (see also WLAN status window and radio cards next
page).
Finally, don't forget to Save!