User manual

UNO-2170 User Manual 16
Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
1. Remove the power cord.
2. Unscrew the four screws from the rear panel of the UNO-2170.
3. Remove the rear panel.
4. Plug a CompactFlash card with your OS and application program
into a CompactFlash card slot on board.
5. Screw back the rear panel with four screws.
3.2 Chassis Grounding
UNO-2170 provides good EMI protection and a stable grounding base.
There is an easy-to-connect chassis grounding point for you to use.
Figure 3.1: Chassis Grounding Connection
You can select if you wish to combine the chassis grounding point with
the system grounding by using an onboard jumper selection. (JP7)
Note: The CompactFlash is allocated as “Secondary IDE Master”.
Open - Separates system power ground and chassis
ground. (default)
Closed - Connects system power ground and chassis
ground.