Instruction Manual

Hardware Installation
Step one, wall mounting:
1. Locate the area to install and mark the
four screw locations. If necessary, drill pilot
holes.
If installing in concrete, it is recommended
to use wall sinks.
2. Align the LoRaWAN to the holes on the
location and secure with the screws.
advantech-bb.com
Intelligent Edg e Node - Wirel ess Lo Ra
Status/Sleep/Reset
Status
Step two, routing data cables:
3. Insert the sensor cable through the channel
on the device.
NOTE: Position the cable connector so that
it can be connected to the board.
Connect to sensor
4. Connect the sensor cables to the
connectors on the device.
■ Node with AI/DI/DO
Connect
to sensor
Connector 1
Connector 2
■ Node with RS485
Connect
to power
and
sensor
5. Align the top cover with the base and install
while gently pulling the data cable slack.
If there is resistance when pulling, do not
pull the cable further to avoid damaging the
connector.
6. Secure the top cover with the screws.
advantech-bb.com
Intelligent Ed ge Node - Wire less L oR a
Status/Sleep/Reset
Status