User manual

ARK-4180 User Manual 46
5.1 PC/104
Figure 5.1 PC/104
5.2 DIMM Card
To add a DIMM to the single board computer, follow the steps:
1. Move the module release levers on the single board computer (one on each end
of the socket) outward, away from the socket.
2. Place the DIMM card so that the notch on the contact edge lines up with the
alignment node in the DIMM socket. Insert the DIMM card into the socket.
3. Using both hands, press downward and guide the DIMM card into the socket
until it snaps into place. The module release levers will return to their upright
position when the DIMM card is completely seated in the socket. The pegs on
the tips of the release levers should align with the notches on both ends of the
DIMM card.
Aim the pin connector to the foot print
and apply force evenly.
After applying force to the IPC
connector, the footprint of the
module/CPU board needs to be
inserted correctly.
After applying force to the connector,
the footprint of the module/CPU board
needs to be inserted correctly.
Align the pin connector over the socket
Before
Before