User manual
Table Of Contents
- ARK-3399
- 1 General Introduction
- 2 H/W installation
- 2.1 Introduction
- 2.2 Jumpers
- 2.3 Connectors
- Figure 2.2 ARK-3389 IO connectors drawing
- 2.3.1 ARK-3399 external I/O connectors
- 2.3.1.1 COM Connectors
- 2.3.1.2 Ethernet Connector (LAN)
- 2.3.1.3 PS2 Keyboard/Mouse Connector
- 2.3.1.4 VGA Connector
- 2.3.1.5 USB Connector
- 2.3.1.6 Power Input Connector
- 2.3.1.7 Power ON/OFF Button
- 2.3.1.8 LED Indicators
- 2.3.1.9 Audio Connector
- 2.3.1.10 DIO Connector
- 2.3.1.11 LVDS Connector
- 2.3.1.12 LCD Backlight On/Off control Connector
- 2.4 Installation
- 3 BIOS Operation
- 3.1 BIOS Introduction
- 3.2 BIOS Setup
- 3.2.1 Main Menu
- 3.2.2 Standard CMOS Features
- 3.2.3 Advanced BIOS Features
- 3.2.4 Advanced Chipset Features
- 3.2.5 Integrated Peripherals
- 3.2.6 Power Management Setup
- 3.2.7 PnP/PCI Configurations
- 3.2.8 PC Health Status
- 3.2.9 Frequency/Voltage Control
- 3.2.10 Load Optimized Defaults
- 3.2.11 Set Password
- 3.2.12 Save & Exit Setup
- 3.2.13 Quit Without Saving
- 4 Full Disassembly Procedure
- 4.1 Introduction
- Figure 4.1 Unscrew the bottom screws
- Figure 4.2 Unscrew the frame screws and remove the frame
- Figure 4.3 Unscrew the panel screws
- Figure 4.4 Unscrew the hex-bolts on the panel
- Figure 4.5 Unscrew the ground wire of LVDS cable and disconnect all the cables and boards
- Figure 4.6 Unscrew the boards’ screws and hex-bolts for disassembly
- Figure 4.7 Unscrew the power module screws on the bottom to disassemble the power module
- 4.1 Introduction
31 ARK-3399 User Manual
Chapter 3 BIOS Operation
Video Off in suspend [Yes]
This item allows user to determine the manner is which the monitor is blanked.
No Screen is off occasion when system into suspend mode.
Yes Screen is never be turn off.
Suspend Type [Stop Grant]
This option controls processor power control in two states “PwrOn Suspend” and
“Stop Grant”. User can select the state depending on your need. It is
recommended to select ìPwrOn Suspendî. The default is “Stop Grant”.
Stop Grant When in this state, the CPU has internal clock running and may
respond to interrupts and other signals. The CPU may transition
from Stop Grant state to Normal state, AutoHalt mode and Sleep
mode.
PwrOn Suspend When in this state, the CPU keep in low-power status and power
still on.
Modem use IRQ [3]
This item allows user to determine the IRQ which the MODEM can use.
Suspend Mode [Disabled]
This item allows user to determine suspend of timer.
HDD Power Down Mode [Disabled]
This item allows user to determine the time of system inactivity, the hard disk drive
will be powered down.
Soft-Off by PWR-BTTN [Instant-Off]
This item allows user to define function of power button.
Instant-Off Press power button then Power off instantly.
Delay 4 Sec Press power button 4 sec. to Power off.
Energy Lake Function [Disable]
This item allows user to disable Video output, Fanís doesnít stop, and computer
doesn't go to standby. Pressing any button on keyboard re-enables video output.
PWRON After PWR-Fail [Off]
This item allows user to select power fail function, The functions is depend on chipset
design.
Wakeup By PCI Card [Press Enter]
This item allows user to selection wake up by PCI Device.
Power On By Ring [Disabled]
This item allows determine that resume by modem ring. System default is setting to
“Disabled” to reference value.
Resume By Alarm [Disabled]
This item allows user to enable and key in Date/time to power on system
Disabled Disable this function.
Enabled Enable alarm function to power on system
Data (of month) Alarm1-31
Resume Time (HH:MM:SS)Alarm (0-23) : (0-59) : 0-59)