User manual

69 Chapter 4
4.7.16 Time (hh:mm:ss) Alarm
This is used to set the time you would like the system to power-on. If you
want the system to power-on everyday as set in the “Date (of Month)
Alarm” field, the time set in this field must be later than the time of the
RTC set in the Standard CMOS Features submenu.
4.7.17 Primary IDE 0/ 1 and Secondary IDE 0 / 1
When Enabled, the system will resume from suspend mode if Primary
IDE 0 / 1 or Secondary IDE 0 / 1 is active. The choice: Enabled, Disabled.
4.7.18 FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if FDD, COM
port, or LPT port is active. The choice: Enabled, Disabled.
4.7.19 PCI PIRQ [A-D]#
When Enabled, the system will resume from suspend mode if an interrupt
occurs. The choice: Enabled, Disabled.
4.7.20 PWRON After PWR-Fail
Off When power returns after an AC power failure, the system’s power
is off. You must press the Power button to power-on the system.
On When power returns after an AC power failure, the system will
automatically power-on
Former-Sts When power returns after an AC power failure, the system
will return to the state where you left off before power failure occurs. If
the system’s power is off when AC power failure occurs, it will remain
off when power returns. If the system’s power is on when AC power fail-
ure occurs, the system will power on when power returns.
4.8 PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers some
very technical items and it is strongly recommended that only experi-
enced users should make any changes to the default settings.
4.8.1 Reset Configuration Data
Default is Disable. Select Enable to reset Extended System Configuration
Data (ESCD) if you have installed a new add-on and system configura-
tion has caused such a conflict that OS cannot boot.