User manual

37 ACP-4362/4360 User Manual
Chapter 5 Alarm Board
5.3 Thermal Sensor
The ACP-4360 is configured with a thermal sensor located at the rear plate of the
chassis. (see Figure 5.2) Refer to Figure 5.3 for a diagram of the thermal sensor
module layout.
Figure 5.2: Thermal sensor location
Figure 5.3: Thermal sensor module
The default sensor I.D. number is 1. Users can refer to Table 5.13 to set the sensor
I.D. number by adjusting the switch, SW1, on the sensor module.
Table 5.12: CN1 & CN2, Temperature sensor connector
Pin 1 +5V Pin 3 T_SDAT
Pin 2 T_SCLK Pin 4 GND
Table 5.13: SW1, Thermal sensor I.D. number setting
Sensor I.D. No. SW 1-1 SW 1-2 SW 1-3 SW 1-4
1 (default) OFF OFF OFF ON
2OFFOFFONON
3 OFF ON OFF ON
4 OFF ON ON ON
5ONOFFOFFON
6ONOFFONON
7ONONOFFON
8 ONONONON
Thermal Sensor