User manual

ACP-4362/4360 User Manual 14
Figure 2.8 Converter for IDE slim-type optical disk drive
Figure 2.9 Installing the slim-type optical disk drive
2.5.2 Installing SATA HDD
ACP-4362 / 4360 supports either SATA or SATA II HDD. Please follow the installation
procedures below to install the SATA HDD into the mobile HDD tray.
1. Open the front door by turning the rotary lock.
2. Push up the latch on the mobile tray to unlock it.
3. Press down the handle of the mobile tray and pull it out as far as it will go. Then
completely take out the tray. (See Figure 2.10)
4. Fix a 3.5" SATA HDD to the proper location in the tray by fastening the screws
provided. (See Figure 2.11)
5. Return the mobile tray with SATA HDD and push it in by the handle until it is
locked into the original position.
6. Push down the latch to lock the tray in place.
7. Repeat Steps 1 to 6 if there is more than one SATA HDD needs to be installed.