User manual

13 ACP-4362/4360 User Manual
Chapter 2 System Setup
2.5 Installing Disk Drives
The APC-4362 / 4360 supports one slim-type optical disk drive, one 3.5" FDD (or
internal HDD) and the mobile storage devices for six SATA HDDs. Please refer to the
following instructions to install the various disk drives.
2.5.1 Installing HDD or FDD or Slim-type Optical Disk Drive
To install the 3.5" FDD (or internal HDD) or the slim-type optical disk drive, please fol-
low these steps for installation.
1. To install the 3.5" FDD or internal HDD, simply release the two screws on top of
the disk drive bracket. Then remove the front cover as well if you want to install
the FDD.
2. Insert the disk drive into the proper location in the bracket and secure them with
the screws provided. (see Figure 2.7)
3. Return the bracket with the disk drive in the original position and fasten it with
the screws.
Figure 2.7 Installing 3.5" HDD or FDD
4. To install the IDE slim-type optical disk drive, please connect the small converter
(see Figure 2.8) provided in the accessory box to the rear of the optical disk
drive and fasten it by the two screws provided. Users can also purchase an
optional SATA power wire for connecting a SATA slim-type ODD.
5. Undo the screws on the slim-type optical disk drive bracket and its front cover.
Then fix the optical disk drive to the bracket with the four screws provided. (see
Figure 2.9)
6. Return the bracket with the slim-type optical disk drive in the original position
and fasten it with the screws.
7. Connect a 40-pin IDE flat cable from the CPU card or the motherboard to the
3.5" internal HDD or the slim-type optical disk drive, or a 34-pin flat cable to a
FDD. Then plug the power connector into each disk drive