User manual

11 ACP-4362/4360 User Manual
Chapter 2 System Setup
2.3 Installing CPU Card or Add-on Card
ACP-4362 / 4360 supports up to 15 cards. To install a CPU card or add-on card,
please proceed as follows:
1. Select a vacant PICMG slot for the full-length CPU card, or a PCI/ISA slot for
other add-on cards. Then, remove the corresponding I/O bracket attached to the
rear plate of the chassis.
2. Insert the CPU card (with CPU, CPU cooler, RAM, and necessary cables
installed) or add-on card vertically into the proper slot. For full-length CPU card,
please make sure that the card bracket has been inserted properly and the
other edge of the card has been inserted into the plastic guiding fillister. Fasten
the screws on the top of both brackets of the card. (see Figure 2.5)
3. Repeat Step 1 and 2 if there is more than one add-on card to be installed.
4. Connect the 9-pin USB wire, Power switch wire, and the System Reset switch
wire from the chassis to the CPU card.
5. Connect the wire of LAN LED from the chassis to the CPU card. Connect the
wire of HDD LED from the SATA HDD backplane to the CPU card.
6. For the PICMG 1.0 BACKPLANE, connect the orange-white wire from the con-
nector “CN20” on the CPU card to connector “HCN1” on the backplane. Con-
nect the power switch wire from the chassis to connector “CN21” on the CPU
card.
Figure 2.5 Installing a CPU card