User manual
ACP-4010 User Manual iv
e The equipment has been dropped and damaged.
f The equipment has obvious signs of breakage.
16. THE COMPUTER IS PROVIDED WITH CD DRIVES COMPLY
WITH APPROPRIATE SAFETY STANDARDS INCLUDING
IEC 60825.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
17. This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including
interference that may cause undesired operation.
Caution!
The computer is provided with a battery-powered
real-time clock circuit. There is a danger of explosion
if battery is incorrectly replaced. Replace only with
same or equivalent type recommended by the manu-
facture. Discard used batteries according to the man-
ufacturerÃs instructions.
Caution!
Always completely disconnect the power cord from
your chassis whenever you work with the hardware.
Do not make connections while the power is on. Sen-
sitive electronic components can be damaged by
sudden power surges.
Caution!
Always ground yourself to remove any static charge
before touching the motherboard, backplane, or add-
on cards. Modern electronic devices are very sensi-
tive to static electric charges. As a safety precaution,
use a grounding wrist strap at all times. Place all
electronic components on a static-dissipative surface
or in a static-shielded bag when they are not in the
chassis.