User manual

11 Chapter 2 System Setup
Figure 2.4: Installing a motherboard
2.3 Installing CPU Card or Add-on Card
ACP-4010 supports up to 15 cards. To install a CPU card or add-on card,
please proceed as follows:
1. Select a vacant PICMG slot for the full-length CPU card, or a PCI/
ISA slot for other add-on cards. Then, remove the corresponding
I/O bracket attached to the rear plate of the chassis.
2. Insert the CPU card (with CPU, CPU cooler, RAM, and necessary
cables installed) or add-on card vertically into the proper slot. For
full-length CPU card, please make sure that the card bracket has
been inserted properly and the other edge of the card has been
inserted into the plastic guiding fillister. Fasten the screws on the
top of both brackets of the card. (see Figure 2.5)
3. Repeat Step 1 and 2 if there is more than one add-on card to be
installed.
4. Connect the 9-pin USB wire, power switch wire and system reset
switch wire from the chassis to the CPU card.
5. Connect the wire of LAN LED and HDD LED from the chassis to
the CPU card.