User manual

9 Chapter 2 System Setup
2.2 Installing the Backplane or Motherboard
ACP-4010 supports either; an up to 15-slot backplane or ATX mother-
board. To install the backplane or motherboard, please proceed as fol-
lows:
1. Dismantle the hold-down clamp by removing the two screws on its
both ends.
2. A yellow label is located inside of the chassis bottom. (see Figure
2.2) It shows the copper stub locations for attaching the specific
backplane or motherboard. Users can find the copper stubs in the
accessory box. Be sure to follow the instruction and fasten the
backplane or motherboard onto the chassis with the correct stub
locations.
3. While installing a BACKPLANE, fasten it in place and attach the
supplied EMI spring shielding with the screws provided. (see Fig-
ure 2.3)
4. For the PICMG 1.0 BACKPLANE, connect the orange-white wire
from connector ‘HCN1’ on the backplane to connector ‘CN21’ on
the CPU card.
5. While installing a MOTHERBOARD, attach the motherboard I/O
shielding onto the rear plate first. Then fasten the motherboard onto
the chassis. (see Figure 2.4)
6. Connect the 20-pin (or 24-pin) ATX power connector and the 4-pin
+12 V power connector from the power supply to the backplane or
the motherboard. (For the PICMG 1.0 BACKPLANE, the 4-pin
+12 V power connector is connected to the CPU card.)
7. Connect the 9-pin USB wire, Power switch wire, and the System
Reset switch wire from the chassis to the motherboard.
8. Connect the wire of LAN LED and HDD LED from the chassis to
the motherboard.
Caution! Use caution when installing a motherboard. It is
highly recommended to integrate Advantech
motherboard series with ACP-4010 chassis to
ensure the quality, safety and the air flow design.