User manual

ACP-4010 User Manual 8
Chapter 2 System Setup
The following procedures instruct users to install a backplane/mother-
board, add-on cards and disk drives into the ACP-4010. Please also refer
to Appendix A, Exploded Diagram, for the detailed parts of ACP-4010.
2.1 Removing the Chassis Cover
To remove the cover of ACP-4010, please proceed as below.
1. Loosen the two thumb screws on the rear of the top cover.
2. Pull the chassis top cover backwards and then lift it up.
Figure 2.1: Removing the chassis top cover
Caution! Use caution when installing or operating the
components with the chassis open. Be sure to
turn off the power, unplug the power cord and
ground yourself by touching the metal chassis
before you handle any components inside the
machine.