User manual

ACP-2320MB User Manual 12
2.4.3 Installing a slim-type optical disk drive
1. Undo the two screws on the top of the SAS / SATA HDD housing and take out
the brackets.
2. Remove the front cover for the slim-type optical disk drive.
3. Find a small PCB converter (See Figure 2.10) and connect it to the slim-type
optical disk drive. Then fix it onto the optical disk drive by tightening the two
screws provided. (See Figure 2.11)
4. Fix the optical disk drive onto the brackets with the four screws provided.
5. Return the brackets with the slim-type optical disk drive in the original position
and fasten it with the screws.
6. Connect the 40-pin IDE flat cable from the motherboard to the optical disk drive.
Also plug the 4-pin power connector.
Figure 2.10 Small convert for slim-type optical disk drive
Figure 2.11 Installing a slim-type optical disk drive