User manual

11 ACP-2320MB User Manual
Chapter 2 System Setup
2.4.2 Installing the internal HDD
The ACP-2320MB provides a shockproof housing to hold two 3.5” internal HDDs. To
install the internal HDD, please follow these steps for installation.
1. To install the 3.5” internal HDD, simply release the four screws on top of the disk
drive bracket. (see Figure 2.9)
2. Insert the disk drive into the proper location in the bracket and secure them with
the screws provided.
3. Return the disk drive bracket in the original position and fasten it with the
screws.
4. Connect the suitable cable from the motherboard to the 3.5” internal HDD. Then
plug the power connector into each disk drive.
Figure 2.9 Installing the internal HDD