User manual

ACP-2320MB User Manual 10
2.4 Installing the Disk Drives
The ACP-2320MB comes with two easy-to-maintain SAS / SATA HDD trays; it also
accepts one slim type optical disk drive; it can also accommodate two internal 3.5”
HDDs. Please refer to the following instructions to install the various disk drives.
2.4.1 Installing a SAS / SATA HDD in the Mobile HDD tray
ACP-2320MB accepts both SAS and SATA HDD. Users do not need to remove chas-
sis cover when installing a SAS / SATA HDD into the mobile HDD trays.
1. Open the front door.
2. If you want to install a SAS / SATA HDD into the lower mobile tray, it is neces-
sary to remove the front door first. The small door is attached to the ACP-
2320MB with the hinges without screws.
3. Left-shift the key latch of one HDD tray to unlock the tray. Hold the handle of the
tray and draw it out from the chassis.
4. Slide one SAS / SATA disk drive into the proper location in the tray and fix it with
4 ~ 6 screws.
5. Return and push the HDD tray to the chassis until the handle of tray is moving
back. Right-shift the key latch of the HDD tray to lock the tray.
6. Repeat Steps 3 to 5 if there is the 2nd SAS / SATA HDD to be installed.
Figure 2.7 Removing the front door and the mobile SAS / SATA HDD trays
Figure 2.8 Installing a SAS / SATA HDD