User manual

9 ACP-2320MB User Manual
Chapter 2 System Setup
2.3 Installing a Riser Card and Add-on Cards
The ACP-2320MB supports up to 3 add-on cards via the riser card. To install the riser
card and add-on cards, please proceed as follows:
1. Fasten the riser card to the riser card holder with the four screws. Then insert
this unit to the slot on the motherboard. (see Figure 2.5)
2. Remove the corresponding I/O bracket attached to the rear plate of the chassis.
Insert an add-on card vertically into the proper slot on the riser card. For full-
length cards, please make sure that the card bracket has been inserted properly
and the other edge of the card has been inserted into the plastic guiding fillister.
Then fasten the screws on the top of the I/O bracket. (see Figure 2.6)
3. Repeat Step 2 if there is more than one add-on cards to be installed.
4. Return the riser card holder and fasten it onto the chassis
.
Figure 2.5 Installing a riser card
Figure 2.6 Installing an add-on card
If users purchase the ACP-2320MB with the low profile rear I/O bracket, then simply
install the low-profile add-on card to the selected PCI/PCIe slot on the motherboard
and fasten the card securely.
Note! The riser card of the motherboard is specially designed to support
Advantech AIMB-7XX and AIMB-5XX series. There might be compatibil-
ity issue with other vendor’s motherboards.