User manual
Table Of Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- 2.1 System installation
- 2.2 Installing motherboard
- 2.3 Installing passive backplane & CPU card
- 2.4 Installing plug-in cards
- 2.5 Installing disk drives
- 3.1 The Front Section of ACP-4320
- 3.2 Replacing the fans
- 3.3 Cleaning the filters
- 3.4 Replacing the power supply
- 4.1 Alarm board layout
- 4.2 Alarm board specifications
- 4.3 Switch settings
- 4.4 Thermal sensor
- Appendix A Exploded Diagram
- Appendix B Safety Instructions
- B.1 English
- B.2 German - Wichtige Sicherheishinweise
29
connector(s) from the CD-ROMs, the hard drive disk(s), and the two-
bay SATA HDD backplane.
5. Remove the four screws which mount the failed redundant power
supply to the ACP-4320 chassis, then take out the power supply.
6. Place a new redundant power supply into the chassis and fix it with the
four screws.
7. Plug the ATX power connector and +12V power connector to the CPU
card/motherboard, as well as the floppy drive power connector and the
peripheral power connector(s) to the proper disk drives.
8. Replace the hold down clamp and fix it with the two screws.
9. Replace the upper cover of ACP-4320 and plug in the power cord.