User manual
Table Of Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- 2.1 System installation
- 2.2 Installing motherboard
- 2.3 Installing passive backplane & CPU card
- 2.4 Installing plug-in cards
- 2.5 Installing disk drives
- 3.1 The Front Section of ACP-4320
- 3.2 Replacing the fans
- 3.3 Cleaning the filters
- 3.4 Replacing the power supply
- 4.1 Alarm board layout
- 4.2 Alarm board specifications
- 4.3 Switch settings
- 4.4 Thermal sensor
- Appendix A Exploded Diagram
- Appendix B Safety Instructions
- B.1 English
- B.2 German - Wichtige Sicherheishinweise
ACP-4320 User Manual 18
2.5.2 Installing a 3.5" floppy disk drive
1. Remove the cover of one 3.5" drive bay.
2. Insert one 3.5" floppy disk drive into the proper location in the FDD
bracket and fix it with four screws.
3. Attach the FDD bracket to the drive bay unit and fix it with two
screws.
4. Connect a 34-pin flat cable from the CPU card/motherboard to the
floppy disk drive.
5. Plug in a floppy drive power connector from the power supply to the
floppy disk drive.
2.5.3 Installing an internal hard disk drive in the 3.5" drive bay
1. Insert one 3.5" hard disk drive into the proper location in the FDD
bracket and fix it with four screws.
2. Attach the FDD bracket to the drive bay unit and fix it with two
screws.
3. Connect a 40-pin flat cable from the CPU card/motherboard to an
ATA (IDE) hard disk drive or a SATA cable to a SATA hard disk
drive.
4. Plug in a peripheral power connector from the power supply to the
hard disk drive.