User manual
Table Of Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- 2.1 System installation
- 2.2 Installing motherboard
- 2.3 Installing passive backplane & CPU card
- 2.4 Installing plug-in cards
- 2.5 Installing disk drives
- 3.1 The Front Section of ACP-4320
- 3.2 Replacing the fans
- 3.3 Cleaning the filters
- 3.4 Replacing the power supply
- 4.1 Alarm board layout
- 4.2 Alarm board specifications
- 4.3 Switch settings
- 4.4 Thermal sensor
- Appendix A Exploded Diagram
- Appendix B Safety Instructions
- B.1 English
- B.2 German - Wichtige Sicherheishinweise
17
.
Figure 2.5: Installing the drives
2.5.1 Installing a 5.25" disk drive
1. Remove the two screws, which mount the FDD bracket to the drive
bay unit.
2. Remove the four screws, which mount the drive bay to the chassis,
then take out the drive bay.
3. Remove the cover of one 5.25" drive bay. Insert one 5.25" disk drive
(e.g., 5.25" CD-ROM/-RW) into the proper location in the drive bay
and fix it with four screws.
4. Connect a 40-pin flat cable from the CPU card/motherboard to the
CD-ROM.
5. Plug in a peripheral power connector from the power supply to the
CD-ROM.
6. Repeat Steps 3 ~ 5 if there is more than one drive.
7. Return the drive bay unit into the ACP-4320 chassis and fix it with the
four screws.