User manual
Table Of Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- 2.1 System installation
- 2.2 Installing motherboard
- 2.3 Installing passive backplane & CPU card
- 2.4 Installing plug-in cards
- 2.5 Installing disk drives
- 3.1 The Front Section of ACP-4320
- 3.2 Replacing the fans
- 3.3 Cleaning the filters
- 3.4 Replacing the power supply
- 4.1 Alarm board layout
- 4.2 Alarm board specifications
- 4.3 Switch settings
- 4.4 Thermal sensor
- Appendix A Exploded Diagram
- Appendix B Safety Instructions
- B.1 English
- B.2 German - Wichtige Sicherheishinweise
ACP-4320 User Manual 16
2.5 Installing disk drives
The ACP-4320 comes with two front-accessible SATA HDD trays; it
also accepts two 5.25" disk drives and one 3.5"flppy disk drive or an
internal SATA/ATA hard disk drive.
Note: For the first time to install all disk drives
together into the ACP-4320 chassis, we
suggest users to install the two 5.25" disk
drives (refer to Section 2.5.1) first, then the
3.5" floppy disk drive (refer to Section
2.5.2) or internal 3.5" hard disk drive (refer
to Section 2.5.3), and finally, the dual
SATA hard disk drives into the front-acces-
sible SATA HDD trays (refer to Section
2.5.4).
Note: The ACP-4320's dual front-accessible
SATA HDD trays do not support the hot
swappability feature. To fulfill this feature, it
is necessary to use a SATA RAID card.