User manual
Table Of Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- 2.1 System installation
- 2.2 Installing motherboard
- 2.3 Installing passive backplane & CPU card
- 2.4 Installing plug-in cards
- 2.5 Installing disk drives
- 3.1 The Front Section of ACP-4320
- 3.2 Replacing the fans
- 3.3 Cleaning the filters
- 3.4 Replacing the power supply
- 4.1 Alarm board layout
- 4.2 Alarm board specifications
- 4.3 Switch settings
- 4.4 Thermal sensor
- Appendix A Exploded Diagram
- Appendix B Safety Instructions
- B.1 English
- B.2 German - Wichtige Sicherheishinweise
ACP-4320 User Manual 12
5. Refer to Figure 2.2, place the motherboard into the chassis, and fix it
with screws.
6. Plug in the 20- or 24-pin ATX power connector and +12 V power con-
nector from the power supply.
7. Connect the wires for the POWER switch, RESET switch, and the
front USB from the motherboard to the front panel of the chassis.
8. Connect the wires for the POWER LED, HDD LED and LAN LED
from the motherboard to the small LED board, which is attached to the
front panel of the chassis.
Figure 2.2: Installing a motherboard
Note: All Advantech's industrial ATX/microATX
motherboards support the front USB func-
tion. However, only the AIMB-750, 760,
762, 560 and the later industrial mother-
boards support the front LAN LED function.