User manual
Table Of Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- 2.1 System installation
- 2.2 Installing motherboard
- 2.3 Installing passive backplane & CPU card
- 2.4 Installing plug-in cards
- 2.5 Installing disk drives
- 3.1 The Front Section of ACP-4320
- 3.2 Replacing the fans
- 3.3 Cleaning the filters
- 3.4 Replacing the power supply
- 4.1 Alarm board layout
- 4.2 Alarm board specifications
- 4.3 Switch settings
- 4.4 Thermal sensor
- Appendix A Exploded Diagram
- Appendix B Safety Instructions
- B.1 English
- B.2 German - Wichtige Sicherheishinweise
ACP-4320 User Manual 10
Chapter 2 System Setup
The following procedures are provided to assist you in installing a moth-
erboard (or backplane), disk drives, and plug-in cards into the ACP-4320.
Please also refer to the Appendix A, Exploded Diagram, for the parts
naming in this manual.
2.1 System installation
To remove the cover of the ACP-4320, please refer to Figure 2.1.
Figure 2.1: Removing the cover
Note: The ACP-4320 accepts either an ATX/
microATX motherboard (model P/N: ACP-
4320MB) or an up to 15-slot backplane
(model P/N: ACP-4320BP). If you have
purchased an ACP-4320MB chassis,
please refer to Section 2.2 for the instruc-
tions to install an ATX/microATX mother-
board; otherwise, please refer to Section
2.3 to install a backplane and a CPU card.