User manual
Table Of Contents
- Chapter 1 General Information
- Chapter 2 System Setup
- 2.1 System installation
- 2.2 Installing motherboard
- 2.3 Installing passive backplane & CPU card
- 2.4 Installing plug-in cards
- 2.5 Installing disk drives
- 3.1 The Front Section of ACP-4320
- 3.2 Replacing the fans
- 3.3 Cleaning the filters
- 3.4 Replacing the power supply
- 4.1 Alarm board layout
- 4.2 Alarm board specifications
- 4.3 Switch settings
- 4.4 Thermal sensor
- Appendix A Exploded Diagram
- Appendix B Safety Instructions
- B.1 English
- B.2 German - Wichtige Sicherheishinweise
ACP-4320 User Manual 4
1.4 Power supply options
1.4.1 300W ATX power supply with PFC (PS-300ATX-ZB)
• Output rating: 300 watts max.
• Input rating: 100 ~ 240 Vac @ 50 ~ 60 Hz (full range)
• Output voltage: +5 V @ 30 A, +3.3 V @ 28 A, +12 V @ 15 A, -5 V
@ 0.3 A, -12 V @ 0.3 A, +5 VSB @ 2 A
• Minimum load: +5 V @ 0.1 A, +3.3 V @ 0.3 A
• MTBF: 100,000 hours @ 25° C, full load
• Safety: UL/cUL/TUV/CB/CCC
1.4.2 400W ATX power supply with PFC (PS-400ATX-ZB)
• Output rating: 400 watts max.
• Input rating: 100 ~ 240 Vac @ 47 ~ 63 Hz (full range)
• Output voltage: +5 V @ 35 A, +3.3 V @ 25 A, +12 V @ 30 A, -5 V
@ 0.8 A, -12 V @ 1 A, +5 VSB @ 2 A
• Minimum load: +5 V @ 3 A, +3.3 V @ 1 A, +12 V @ 1 A, +5 VSB
@ 0.1 A
• MTBF: 100,000 hours @ 25° C, full load
• Safety: UL/cUL/TUV/CB/CCC
1.4.3 300W ATX redundant power supply (RPS-300ATX-Z)
• Output rating: 300 watts max.
• Input rating: 100 ~ 240 Vac @ 50 ~ 60 Hz (full range)
• Output voltage: +5 V @ 25 A, +3.3 V @ 18 A, +12 V @ 16 A, -5 V
@ 0.5 A, -12 V @ 0.5 A, +5 VSB @ 2 A
• Minimum load: +5 V @ 3 A, +3.3 V @ 1 A, +12 V @ 2 A, +5 VSB
@ 0.1 A
• MTBF: 100,000 hours @ 25° C, full load
• Safety: UL/cUL/TUV/CB/CC