User manual

AIMB-567 User Manual 4
 Power consumption:
+5 V @ 4 A, +3.3 V @ 1.02 A, +12 V @ 2.35 A, 5 VSB @ 0.26 A, -12 V @ 0.12
A Measure the maximum current value which system under maximum load
(CPU: Top speed, RAM & Graphic= full loading).
 Board size: 244 mm x 244 mm (9.6" x 9.6")
 Board weight: 0.75 kg
1.4 Jumpers and Connectors
Connectors on the AIMB-567 motherboard link it to external devices such as hard
disk drives and a keyboard. In addition, the board has a number of jumpers used to
configure the system for your application.
The tables below list the function of each of the board jumpers and connectors. Later
sections in this chapter give instructions on setting jumpers. Chapter 2 gives instruc-
tions for connecting external devices to your motherboard.
Table 1.1: Jumpers
Label Function
CMOS1 CMOS clear
JCASE1 Chassis Instruction Connector
PSON1 AT/ATX mode selector
JSETCOM3 Serial port:RS232/RS422/RS485 jumper setting
Table 1.2: Connectors
Label Function
JFP1 Power Switch / Reset connector
JFP2 External speaker / SATA HDD LED connector / SM Bus connector
JFP3 Power LED
Keyboard Lock and
Power LED
Suspend: Fast flash (ATX/AT)
System On: ON (ATX/AT)
System Off: OFF (AT)
System Off: Slow flash (ATX)
LPT1 Parallel port (on board)
USB56 USB port 5, 6 (on board)
USB78 USB port 7 8(on board)
VGA1 VGA connector
DVI1 Extension I/O board connector 2 (Support DVI)
VOLT1 Connector to check chassis LED board
IDE1 Primary IDE connector (Black)
COM1/COM2 Serial port: COM1/COM2 (9-pin connector)
COM 3 ~ 4 Serial port: COM 3 ~ 4 (40-pin connector)
KBMS1 PS/2 keyboard and Mouse connector Cable length: 20 meter
KBMS2 PS/2 keyboard and Mouse connector (on board)
CPU_FAN1 CPU FAN connector
SYS_FAN1 System FAN connector 1
SYS_FAN2 System FAN connector 2
LAN1_USB12 LAN1/USB port 1, 2