User manual

AIMB-564 User Manual 38
6. JMicron JMB363® Serial ATA RAID connector (7-pin
SATA_RAID1)
This connector is for a Serial ATA signal cable. This connector supports a
Serial ATA hard disk drive, which you can combine with an external
Serial ATA hard disk drive to configure for RAID via the onboard Serial
ATA RAID controller.
Figure 1.14: SATA RAID connector
Note:
The JMicron controller mode item in the BIOS is set to
[BASIC] by default.
When set to [RAID], this item allows you to use the connectors
to build a RAID set. See section “2.4.6 Onboard Device Config-
uration” for details.
Note:
Before creating a RAID set using Serial ATA hard disks, make
sure that you have connected the Serial ATA signal cables
and installed Serial ATA hard disk drives; otherwise, you can-
not enter the JMicron® JMB363 RAID utility and SATA BIOS
setup during POST.
R
P5B-VM DO
P5B VM DO SATA RAID connector
SATA_RAID1
GND
RSATA _TXP1
RSATA _TXN1
GND
RSATA _RXP1
RSATA _RXN1
GND