User manual

35 Chapter 1 Product Information
3. IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal
cable. There are three connectors on each Ultra DMA 133/100/66 signal
cable: blue, black, and gray. Connect the blue connector to the mother-
board’s IDE connector, then select one of the following modes to config-
ure your device.
Figure 1.11: AIMB-564 IDE connector
Drive jumper setting Mode of device(s) Cable connec-
tor
Single
device
Cable-Select or Master - Black
Two
devices
Cable-Select Master Black
Slave Gray
Master Master Black or gray
Slave Slave
Note:
Pin 20 on the IDE connector is removed to match the covered
hole on the Ultra DMA cable connector. This prevents incor-
rect insertion when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66
IDE devices.
Note:
If any device jumper is set as “Cable-Select,” make sure all
other device jumpers have the same setting.
R
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
PRI_EIDE
PIN1
P5B-VM DO
P5B
-
VM DO IDE connector