User manual

AIMB-564 User Manual 34
1.9.2 Internal Connectors
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable.
Insert one end of the cable to this connector, then connect the other end to
the signal connector at the back of the floppy disk drive.
Figure 1.9: Floppy Disk Drive Connector
2. Digital Audio connector (4-1 pin SPDIF_OUT)
This connector is for the S/PDIF audio module to allow digital sound out-
put. Connect one end of the S/PDIF audio cable to this connector and the
other end to the S/PDIF module.
Figure 1.10: SPDIF OUT connector
Note:
The S/PDIF out module is purchased separately.
Note:
Pin 5 on the connector is removed to prevent incorrect cable
connection when using a FDD cable with a covered Pin 5.
R
PIN 1
NOTE:
Orient the red markings on
the floppy ribbon cable to PIN 1.
FLOPPY
P5B-VM DO
R
SPDIF_OUT
+5V
Spdif out
GND
P5B-VM DO
P5B-VM DO SPDIF OUT connector