User manual

13 IPC-603MB User Manual
Chapter 3 Operation
3.3 Replacing the filters
To change the filters, refer to Figure 3.2 and proceed as follows:
1. Open the top cover of the chassis.
2. Pull out the filters and replace it with a new one.
Figure 3.2 Replacing the filters
3.4 Replacing the power supply
IPC-603MB supports a single 1U-high power supply. To replace the power supply,
refer to Figure 3.3 and proceed as follows:
Figure 3.3 Replacing the power supply
1. Unplug the power cord from the power supply.
2. Remove the top cover of the chassis.
3. Unplug the ATX power connector and +12 V power connector from the mother-
board, and the peripheral power connector(s) from the disk(s).
filterfilter
filter
ATX Power Connector
Floppy Drive Power Connector
+12V Power Connector
Peripheral Power Connector