User manual

7 IPC-603MB User Manual
Chapter 2 System Setup
2.2 Installing a Motherboard
IPC-603MB accepts both ATX and microATX motherboards. To install a mother-
board, please proceed as follows:
1. Remove the three screws from the L-form riser card holder in the chassis.
2. From inside of the chassis, attach the motherboard I/O shield to the front plate
of the chassis.
3. Check all devices, such as CPU, CPU cooler, and RAMs and make sure they
have been installed on the motherboard correctly. Carefully place the mother-
board in the chassis and fix it with screws.
Figure 2.2 Placing a spacer bracket
4. Plug in the 24- or 20-pin ATX power connector and the +12 V power connector
from the power supply.
5. Connect the Power switch, Reset button, Power LED, and HDD LED wires to
the motherboard.
6. Connect the power connectors of the two system fans (on the rear plate of IPC-
603MB) to the motherboard.
7. Re-install the L-form riser card holder and fasten it with screws.
Note! Use a CPU cooler that is less than 60 mm high to ensure the best air
flow inside the chassis.
Note! If you choose Advantech’s AIMB-740, 741, 742, or 76X ATX mother-
board, please find a spacer bracket in the accessory bag and mount it
on location A in the bottom of the chassis before installing the mother-
board.
If you choose Advantech’s AIMB-5XX series of microATX motherboard,
please find a spacer bracket in the accessory bag and mount it on loca-
tion B in the bottom of the chassis before installing the motherboard.