User manual

ACP-2010MB User Manual 6
The following procedures instruct users to install a motherboard, add-on cards, and
disk drives into the ACP-2010MB. Refer to Appendix A, the Exploded Diagram and
the Parts List for more detailed information about parts for the ACP-2010MB.
2.1 Removing the Top Cover
To remove the top cover, please proceed as shown below.
1. Loosen five screws on the rear and both sides of the top cover.
2. Pull the top cover backwards and then lift it up.
Figure 2.1 Removing the chassis top cover
Note! Use caution when installing or operating the components with the chas-
sis open. Be sure to turn off the power, unplug the power cord and
ground yourself by touching the metal chassis before you handle any
components inside the machine.