User`s manual

1-26 Chapter 1: Product introduction

Au dio 2, 4, o r 6-chann el config ur ation

Refer to the audio conﬁguration table for the function of the audio ports in 2, 4,

or 6-channel conﬁguration.

7. USB 2.0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB) ports are

available for connecting USB 2.0 devices.

8. USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports are

available for connecting USB 2.0 devices.

9. VGA port. This 15-pin VGA port connects to a VGA monitor.

10. Serial connector. This 9-pin COM1 port is for serial devices.

11.

PS/2 keyboard port (purple). This port is for a PS/2 keyboard.

1.10.2 Internal con nec tor s

1. F loppy dis k dr ive c onne ctor (34- 1 pin FLO PPY)

This connector is for the provided ﬂoppy disk drive (FDD) signal cable. Insert

one end of the cable to this connector, then connect the other end to the

signal connector at the back of the ﬂoppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when

using an FDD cable with a covered Pin 5.

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

Floppy disk drive connector

PIN 1

FLOPPY

Port Headset

2-channel

4-channel 6-channel

Light Blue Line In Front Speaker Out Front Speaker Out

Lime Line Out Rear Speaker Out Rear Speaker Out

Pink Mic In Mic In Center/Subwoofer