User manual
33 IPC-610 User Manual
Chapter 4 Alarm Board (ACP-4000 only)
4.3 Thermal Sensor
The ACP-4000 is configured with a thermal sensor located at the rear plate of the
chassis. (see Figure 4.2)
Figure 4.2 Thermal sensor location
Please refer to Figure 4.3 for a diagram of the thermal sensor module layout.
Figure 4.3 Thermal sensor module
The default sensor I.D. number is 1. Users can refer to Table 4.13 to set the sensor
I.D. number by adjusting the switch, SW1, on the sensor module.
thermal sensor