User manual

IPC-610 User Manual 26
3.5 Replacing the Power Supply
These chassis support either a single PS/2 or a redundant power supply (not for IPC-
610-E). To replace the power supply, please proceed as below.
3.5.1 Replacing the Single PS/2 Power Supply
1. Unplug the power cord from the power supply.
2. Remove the top cover and the hold-down clamp.
3. Unplug the 20-pin (or 24-pin) ATX power connector and 4-pin +12V power con-
nector from the backplane/motherboard, as well as the power connectors from
all disk drives.
4. Loosen the six screws on the power supply bracket and then gently pull it up
(see Figure 3.10).
5. Replace the power supply with a new one and then fasten it onto the chassis.
6. Plug the 20-pin (or 24-pin) ATX power connector and 4-pin +12V power connec-
tor to the backplane/motherboard, then plug other power connectors to the disk
drives and peripherals.
7. Return the hold-down clamp and top cover, then Plug in the power cord.
Figure 3.10 Replacing the single power supply