User manual

13 IPC-610 User Manual
Chapter 2 System Setup
2.3 Installing CPU Card or Add-on Card
These chassis supports up to 15 cards. To install a CPU card or add-on cards,
please proceed as follows:
1. Select a vacant PICMG slot for the full-length CPU card, or a PCI/ISA slot for
other add-on cards. Then, remove the corresponding I/O bracket attached to the
rear plate of the chassis.
2. Insert the CPU card (with CPU, CPU cooler, RAM, and necessary cables
installed) or add-on card vertically into the proper slot. For full-length CPU card,
please make sure that the card bracket has been inserted properly and the
other edge of the card has been inserted into the plastic guiding fillister. Fasten
the screws on the top of both brackets of the card. (See Figure 2.5)
3. Repeat Step 1 and 2 if there is more than one add-on card to be installed.
4. Connect the 9-pin USB wire, PS/2 wire, power switch wire and the System
Reset switch wire from the chassis to the CPU card.
5. Connect the wire of HDD LED from the chassis to the CPU card.
6. For the PICMG1.0 Backplane, connect the orange-white wire from the connec-
tor ‘CN20’on the CPU card to the connector ‘HCN1’ on the backplane. Connect
the 4-pin +12 V power connector from the power supply to the CPU card.
Figure 2.5 Installing a full-length card