User`s manual

User’s Manual
AIMB-240 Series User’s Manual
57
No Errors
All, but Keyboard
All, but Diskette
All, but Disk/Key
to stop the POST process and notify you
3.5.1.2 IDE Controller Setup
The IDE Controller controls the hard disk drive. Use a separate sub menu to configure each
hard disk drive. The below table will shows the IDE primary master sub menu.
Item Options Description
IDE HDD Auto-detection Press Enter
Press Enter to auto-detect the HDD on
this channel. If detection is successful,
it fills the remaining fields on this
menu.
IDE Primary Master
IDE Primary Slave,
IDE Secondary Master,
IDE Secondary Slave
None
Auto
Manual
Selecting ‘manual’ lets you set the
remaining fields on this screen.
Selects the type of fixed disk. "User
Type" will let you select the number of
cylinders, heads, etc. Note:
PRECOMP=65535 means NONE !
Access Mode
CHS, LBA
Large, Auto
Choose the access mode for this hard
disk
The following options are selectable only if the ‘IDE Channel …’ item is set to ‘Manual’
Cylinder
Min = 0
Max = 65535
Set the number of cylinders for this
hard disk.
Head
Min = 0
Max = 255
Set the number of read/write heads
Precomp
Min = 0
Max = 65535
**** Warning: Setting a value of 65535
means no hard disk
Landing zone
Min = 0
Max = 65535
****
Sector
Min = 0
Max = 255
Number of sectors per track