Instructions

ADAM-6000 User Manual 64
6.3.7 I/O Configuration
After you have completed the general configuration of the selected ADAM-6000 mod-
ule (as described in the previous section), you will need to configure the I/O channels
(e.g., channel range, calibration, and alarm settings). At the same time, you can see
input channel value and set value of output channel in the Status panel. Refer to the
Module Tree Display Area shown in Figure 6.5. When you click on the IP address of
the ADAM-6000 module you wish to configure, you will see two items below the IP
address: the module number (for all-channel configuration) and the module number
followed by "GCL" (for GCL configuration). When you click on the plus and minus
control beside the module number, you will be prompted to enter the password for the
selected module. Once you have entered the correct password, a list of individual
channels (for individual channel configuration) will appear below the module number.
Figure 6.5 All-Channel, Individual Channel, and GCL Configuration Controls
When you click on the module number, the analog input value and configuration set-
tings for all channels will be shown in the Status Display Area. When you click on one
of the individual channel items, the values and configuration settings for only the
specified channel will be shown in the Status Display Area. The following sections
describe the all-channel configuration and individual channel configuration in more
detail.
Note! Do not remove the power from your module when the group configura-
tion function is processing. Otherwise, the module will probably crash.